IOGear GWPAP1 - Manual (Page 17)

17
5. After the NetShair reboots, connect an Ethernet cable.
The Network LED indictor will light solid once a successful
connection has been made.
6. Connect back to NetShair_Nano_XXXX
Wi-Fi network. Go to a website and the Internet will be live.
Access Point Mode Setting
Follow the steps below to setup the NetShair Nano for AP
Mode. If you are unsure about which mode to use, see
Router Mode or AP Mode (page 5) to confirm the proper
setting.
1. Make sure the “NetShair_Nano_XXXX” Wi-Fi network is
connected. Open the NetShair Nano App.
2. On the Home screen, tap Advance Setting.
3. Tap Set Operation Mode and then
Access Point.
4. Tap Restart to save settings.