IOGear GWPAP1 - Manual (Page 11)

11
2. On the Home screen, tap Advance Settings.
3. Tap Set Operation Mode and then tap
Access Point.
4. Tap Restart to save settings.
5. After the NetShair Nano reboots,
connect an Ethernet cable to the
NetShair Nano. The Network LED indicator
will light solid once a successful connection
has been made.
6. Connect back to NetShair_Nano_XXXX
Wi-Fi network. Open your web browser to access the internet.
Access Point Mode Setting
Follow the steps below to setup the NetShair Nano for AP Mode.
If you are unsure about which mode to use, see Router Mode or
AP Mode (page 5) to confirm the proper setting.
1. Make sure the “NetShair_Nano_XXXX” Wi-Fi network is
connected. Open the NetShair Nano App.