IOGear GWPAP1 - Manual (Page 20)

20
Internet Connection
Computer / Other
1. Make sure the
“NetShair_Nano_XXXX”
Wi-Fi network is connected.
Open the Browser and enter
192.168.1.254 into the address
bar to access the web client.
2. On the Operation Mode page,
click the drop down menu and
select
Router, then click
Apply Change. A notification
saying your settings have been
saved will appear, click
Reboot Later to continue
without the NetShair Nano
rebooting.
Router Mode Setting
Follow the steps below to setup the NetShair Nano for Router
Mode. If you are unsure about which mode to use, see Router
Mode or AP Mode (page 5) to confirm the proper setting.
DHCP Setup continue to page 21
DSL Modem Setup continue to page 22