Omega 48 installation manual – 2N Omega 48 - Installation Manual v1.0 User Manual
Page 40
Advertising
2N
®
- OMEGA 48
Installation manual
Installation manual
40
Serves for network parameter setup (IP address/network mask,.).
After the network parameters have been set up you may disconnect.
Always RESET the module using the SW1 button after disconnecting the USB
cable.
Connect a standard direct Ethernet cable into the J1 connector.
This cable connects the VoIP module with your Ethernet network.
After turning the PBX power on you may start configuring the VoIP module.
!
Advertising