2N Omega Lite - Installation Manual v1.9 - Manual (Page 33)

33
Use the USB cable and the hyper-terminal for the initial setting of the IP
address and the network mask; use the (available) web configuration for further
settings.
The system connects to the 10/100BASE-T (Twisted Pair Ethernet) computer
network through a standard direct cable with RJ 45 connectors at the end.
See the VoIP Module User Manual on the enclosed CD for detailed
installation information.
The following is located on the VoIP module:
J1
- RJ45 connector - 8/8 for LAN connection.
J2 - USB connector for USB connection, designed for IP configuration.
J4,J8 - serial connector designed for connection with the main board of the PBX.
J3
- connector for the connection of adapter for an external USB device (module
UMTS-3G).
J5-J7 - connector for maintenance use
J9
- connector for connection of a functional floor*
SW2 - RESET button. Pressing this button will RESET the CPU board.
SW1 - RESET button. Pressing this button will reset default values (after switching
on the PBX hold the button pressed for approximately 20s until LINUX starts).
D1
- green LED
– operation status indication (VoIP module ready for operation,
approximately 20s after light-up).
D2
- red LED
– operation status indication (VoIP module inactive).
D3-D10 - yellow LED – call channels busy signal.
* In preparation