2N Helios IP Verso v1.1 - Manual (Page 91)

91
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
2.4 Completion
Installation Completion
Check the connection of all wires and the RJ-45 plug to the board connector.
Nametag Placing
Every intercom package includes a piece of transparent foil, which can be laser printed.
Cut the printed foil and insert the nametags in the buttons.
You can insert the whole piece of printed foil in the 5-button module without cutting.
Refer to
for nametag printing templates. www.2n.cz
Tag Inserting/Replacing
Remove the frame.
Lift up the button door. The 5-button module buttons have just one door.
Remove the used nametag and insert a new one.
Close the button door.
Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A:
Screw the flush mounting frame in the upper and bottom part.
Version B
Hang the surface mounting frame on the hook in the upper part and then screw it
tight in the bottom part.
Caution
Always use waterproof foil (enclosed or other) for the nametags. Never
use paper or ink jet printing to avoid damage due to water leakage!
Caution
Improper mounting may deteriorate the intercom waterproofness and
water may damage the electronic part.
You can use silicone or some other sealant to seal the box against the wall
if uneven to avoid water leakage and wall damping. Sealing, however, is
unnecessary for the proper function of the intercom.