2N Helios IP Verso v1.1 - Manual (Page 96)

96
2N TELEKOMUNIKACE a.s., www.2n.cz
®
3.2 Intercom Control as Viewed by External User
Quick Dial Buttons
Press the quick dial button on the basic unit to dial the first position in the phone
directory (Phone Book) depending on the model type. Use extending modules to
extend the number of quick dial buttons to up to 146.
By pressing the quick dial buttons you dial the phone numbers assigned to the
particular Phone Book position. Call setup is signalled by a long intermittent or any
other tone depending on the configuration of the PBX connected.
Repeated pressing of one and the same quick dial button during call setup may initiate
call hangup or call termination plus dialling the next phone number of the called
subscriber, or may be assigned no function; refer to the Miscellaneous subsection in
the Configuration Manual.
You can also press the # button anytime to hang up if enabled so in the Hang up by
parameter; refer to the Miscellaneous subsection in the Configuration Manual. #
Calling to Phone Book Position
The Phone Book can contain up to 1999 programmable 2N
®
Helios IP Verso
positions. The quick dial buttons can only be used for positions 1 through 146,
depending on the number of actually installed buttons. You can dial the other positions
using the numeric keypad if the
function is enabled; refer Quick dialling with digits
to the Miscellaneous subsection in the Configuration Manual.
Procedure:
Enter the position number using the numeric keypad (05, 15, 200, e.g. – two digits at
least and four digits at most) and press the * button for confirmation.
You can also press the # button anytime to hang up if enabled so in the Hang up by
parameter; refer to the Miscellaneous subsection in the Configuration Manual. #
Calling to User-Defined Phone Number
If the (refer to the Miscellaneous subsection in the Telephone function enabled
Configuration Manual) parameter is selected, you can dial a user-defined phone
number using the
numeric keypad. 2N
®
Helios IP Verso
Procedure:
Press *. You will hear a continuous tone from the speaker. Enter the phone number via
the numeric keypad and press * again to confirm your dialling.
You can also press the # button anytime to hang up if enabled so in the Hang up by
parameter; refer to the Miscellaneous subsection in the Configuration Manual. #