2 alarm clock, One-time alarm clock – 2N NetStar User Manual User Manual
Page 36
36
5.2 Alarm Clock
There are two ways how to set the alarm clock for your phone. The default alarm
ringing time is 180s. If you are talking, the alarm clock starts ringing 180s after the
call end. The alarm is stopped by lifting the handset or after 4 cycles have been
completed.
One-Time Alarm Clock
Use this service to set the unrepeated alarm clock mode for a certain time and date
values. If you enter time only, the alarm clock setting is valid for the day on which the
service is activated.
Enable alarm clock with date
*50 hhmm*DDMM#
Enable alarm clock without date
*50 hhmm#
Disable alarm clock
#50
where hh means hours, mm minutes, DD days and MM months. Single-digit
parameters are entered with a zero.
Example: Suppose you want to set the alarm clock to May 9 at 6.30 am. After lifting
the handset and hearing the dialtone, enter the service access code *50. You will be
asked to enter the alarm time. Enter 0630. Now you will be asked to enter the date.
Enter 0905. Now the communication system announces that the alarm has been set
successfully and terminates the call.