2N SIP Speaker Installation v2.1 - Manual (Page 25)

25
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N SIP Speaker Status Signalling
®
2N SIP Speaker
®
is equipped with colour LEDs on the front panel, which indicate
operational statuses.
Status LEDs Figure:
Refer to the table below for the list of available operational statuses:
POWER Status
OFF Device powered off
Green (permanent light) Power on, device in operation
RDY/ACT Status
OFF Normal operational status
Green (fast flashing) Call in progress
Red (slow flashing)
After power up – start of the device.
If default values are set – device deletes configuration
Red (permanent light) Device error
Remote Control Status
OFF Normal operational status
Red (one flash) Infrared remote control signal received
Operational Status Signalling
2N SIP Speaker
®
signals acoustically changes of and transitions between variable
operational statuses. There are different tone combinations for each status change.
Refer to table below for the list of signals.
Tones Meaning
User activated
Used when the user activation code is entered. The activation
code is used for user (telephone directory position) activation.
Refer to the Telephony Directory subsection for activation code
settings.