2N Helios IP Automation Manual v2.7 - Manual (Page 26)

26
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Action.StartMulticastRecv: Chanel=1; Address=239.0.0.1; Port=10000
Action.StopMulticastRecv
The block defines the stopping action for audio stream receiving StopMulticastRecv
to a multicast IP address.
Parameters
Event – define the event to launch this action.
Condition – define the condition to be met for the action to be executed. This
parameter is optional.
Channel – define the channel number (1-4) to be controlled.
Example
Stop audio stream receiving via channel 1 if the event defined on row 2 arises:
Action.StopMulticastRecv: Channel=1
Action.SetCameraInput
The block defines the action that switches the video signal sources – SetCameraInput
either the integrated video camera or an external IP camera, or two inputs for
analogue camera connection to the 2N Helios IP Video Kit.
®
Parameters
Event – define the event to launch this action.
Condition – define the condition to be met for the action to be executed. This
parameter is optional.
Type – define the video signal type. A change during a call will apply only for this
call. Other video receivers receive video from the same source
.
Valid values:
internal – internal camera (or external analogue video camera
connected directly to the device)
external – external IP camera.
The parameter is optional, the default value is . internal
Id – define the video signal channel. The parameter is available with the 2N
®
Helios IP Video Kit model only and applicable only if the Type parameter is set to
. internal
Valid values:
1 – analogue camera connected to input 1
2 – analogue camera connected to input 2