AirLive FE-200DM - Manual (Page 48)

5. Appendix
AirLive FE-200DM Manual 42
5
5.
Appendix
Appendix A: Restore Factory Default
In some cases, system does not respond to any operation, this process gets the unit back
to initial status, so that it can be reconfigurable for up and running again.
To restore factory default, please follow the steps:
1. Unplug the power jack to turn off the camera
2. Insert a pin into the reset hole pressed the reset button and keep it pressed until
instructed to release.
3. Plug in the power jack to turn on the camera. The power LED will start flashing in a
short while.
4. Release the pin when the LED starts quick flashing. The device should be set back to
factory default.