AirLive FE-200DM - Manual (Page 51)

5. Appendix
AirLive FE-200DM Manual 45
The device can be
used outdoors or not. The device is not weatherproof. It needs to be
equipped with a weatherproof case for outdoors using.
However, equipped with a weatherproof case might
disable the audio function of the device.
Install this device
Status LED does not
light up. • Check and confirm that the DC power adaptor,
included in packaged, is used. Secure the power
connector and re-power it on again.
• If the problem is not solved, the device might be faulty.
Contact your dealer for further help.
The network cabling is
required for the
device. The device uses Category 5 UTP cable allowing 10
and/or 100 Base-T networking.
The device will be
installed and work if a
firewall exists on the
network.
If a firewall exists on the network, port 80 is open for
ordinary data communication. The HTTP port and
RTSP port need to be opened on the firewall or NAT
router.
The username and
password for the first
time or after factory
default reset Username = admin and Password = airlive.
Note that it’s all case sensitivity.
Forgot the username
and password Please refer to FAQ A for Restore Factory Default
instruction.
Default IP address is 192.168.1.100
Username/Password is admin/airlive
Forgot the IP address
of the device. Check IP address of device by using the IPWizard II
program or by UPnP discovery.
IPWizard II program
cannot find the device. • Re-power the device if cannot find the unit within 1
minutes.
• Do not connect device over a router. IPWizard II
program cannot detect device over a router.
• If IP address is not assigned to the PC which running
IPWizard II program, then IPWizard II program cannot
find device. Make sure that IP address is assigned to
the PC properly.
• Antivirus software on the PC might interfere with the