AirLive WIAS-3200N - Manual (Page 23)

3. Combine WIAS-3200N to the Network
AirLive WIAS-3200N User’s Manual
20
¾ Network Interface:
o
Operation Mode: Contains NAT mode and Router mode. When NAT mode
is chosen, the service zone runs in NAT mode. When Router mode is chosen,
this zone runs in Router mode.
o
IP Address: The IP Address of this zone.
o
Subnet Mask: The subnet Mask of this zone.
¾ DHCP Server: Related information needed on setting up the DHCP Server is listed
here. Please note that when “Enable DHCP Relay” is enabled, the IP address of
clients will be assigned by an external DHCP server. The system will only relay
DHCP information from the external DHCP server to downstream clients of this
zone.
o
Start IP Address / End IP Address: A range of IP addresses that the built-in
DHCP server will assign to clients.
Note: please change the Management IP Address List accordingly (at
System >> General >> Management IP Address List) to permit the
administrator to access the WIAS-3200N admin page after the default IP
address of the network interface is changed.
o
Preferred DNS Server: The primary DNS server that is used by this Zone.
o
Alternate DNS Server: The substitute DNS server that is used by this Zone.