APG LPU-2428 user manual - Manual (Page 11)

Rev. A3, 11/08 LPU-2428
11
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Programming
The LPU is programmed using the RST-4001 programmer via the keypad &
display or the USB interface & computer software.
RST Programming:
The LCD display shows the distance measurement. The display is also used
to view the individual modes and their values when programming.
The LPU has five programming or navigation buttons, LEFT Arrow, RIGHT
Arrow, UP Arrow, DOWN Arrow, and ENTER (I/O). The arrow buttons allow the
user to move through the pages in order to access and change parameters.
Once a parameter has been changed press the I/O to save.
To select a page, press the UP Arrow or DOWN Arrow button until the
desired page is displayed. Press the Right arrow to move into that page. Then
press the UP or DOWN Arrow button to move to the desired parameter. When
the parameter is shown press the RIGHT Arrow button. The display will show
the name of this parameter on the lower line and the current value on the upper
line of the display. To change the parameter’s value, press the UP Arrow or
DOWN Arrow button until the desired value is displayed.
To store or save the changed value, press the I/O button once. At this point,
the parameter value has been saved. The values are stored in nonvolatile
memory, and will not be lost when power is turned off.
Use the provided terminal strip and
resistor to establish communication
with the RST-4001. Follow the wiring
diagram shown on the previous page.