APG LPU-2428 user manual - Manual (Page 12)

LPU-2428 Rev. A3, 11/08
12
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
• Computer Programming
The utility program used for setting up the sensor is supplied on a 3.5 inch
CD. Install the software by running the Windows Installer Package titled,
“Setup”. The installation process will prompt you as needed to complete the
installation. This will load the operating program to your hard drive. The setup
program can be run from the Windows “START” menu “RUN” option by
entering the file location and name, or by going to Windows Explorer, locating
the file and double clicking on “LPU-2428.EXE”. The setup program will create
an “APG” folder under the Windows program menu.
When the program screen comes up, there are several buttons and windows
to view information. The lower right side of the screen contains two windows
indicating the communication status of the sensor and computer. It will indicate
"Sensor NO Communication", or "Sensor Communicating". If an error is
indicated, then check for proper connections. Allow a moment for the
communication to be established while watching the status window to indicate
"Sensor Communicating". If this fails to establish communication, plug the USB
cable into the second port on the back of the computer. After communication is
established, click on the "Receive" button to load the sensor settings into the
programming windows. Changes to the parameters are accomplished by
clicking in the appropriate text box window, entering the desired value, then
clicking the "Send" button. The "Reset" button will load the factory settings
into the sensor. The program is closed by clicking on the "Exit" button.