APG LPU-2428 user manual - Manual (Page 13)

Rev. A3, 11/08 LPU-2428
13
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
For software users the LPU can be set up using the following seven pages.
Note: When entering parameter changes in the software, be sure to SEND
these changes to the sensor before exiting the software. Failure to do so will
result in unchanged parameter values.
Main:
Displays distance or level. A graphical representation is displayed if measuring
level, volume, or flow.
Basic Setup:
Submenu contains Units, Application, Flow/Volume Units, Flow Rate, and
Response Time.
Note: Changing unit and rate values in Basic Setup will NOT update values
found in the App. Setup and 4-20 Setup pages.
App. Setup:
Submenu contains Volume Tank Type, Flow Type, Max/Full Distance, Zero/
Empty Distance, and values for flow or volume.
4-20 Setup:
Submenu contains Min & Max mA Setpoints, Fail Safe, and Fail Safe Delay.
Calibration (not required on most applications):
Submenu contains Min & Max mA Value, Min & Max mA Trim, Multiplier, and
Offset.
Advanced:
Submenu contains Temperature Compensation, Gain Control, Sensitivity, Pulses,
and Blanking.
Utilities:
Submenu contains Low & High Distance Simulation, Simulation Cycle Time,
Reset, File System, and Software Version.