APG LPU-2428 user manual - Manual (Page 28)

LPU-2428 Rev. A3, 11/08
28
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
can be extended and used to ignore unwanted targets close to the
sensor such as welds, seams, pipe fittings, and gaskets.
1.00 – 25.00 ft
Default: 1.00 ft
Utilities (Utilitie)
Simulation allows the user to input a simulated low level, high level and
the cycle time of the simulation. After these parameters are entered and
the simulation is activated the level reading will move linearly between
the programmed points at the specified interval.
Low Distance Simulation (LoDisSim)
1.00 – 25.00 ft
Default: 1.00
High Distance Simulation (HiDisSim)
1.00 – 25.00 ft
Default: 25.00
Simulation Cycle Time (SimCycle)
ON/OFF 0 – 9 seconds = OFF, 15 – 9999 = ON
Default = OFF
Reset (Reset)
Resets the sensor to factory defaults.
No Reset – Sensor Reset
Default: No Reset
File System (Only available through computer software)
Allows the user to save, load and edit text files that contain sensor
parameters.
Sensor to File
File to Sensor
Compare Sensor to File
Default: none