Blue Sea Systems 4374 WeatherDeck 12V DC Waterproof Circuit Breaker Panel - Gray 4 Positions - Manual (Page 2)

Installation
(continued)
Apply 12V DC or 24V DC label and circuit labels.
Check that appropriately sized circuit breakers are installed for each device.
6. Make connections as per diagram at right.
a. Connect + 12V DC or + 24V DC to the 12 AWG wire supply harness.
b. Connect positive side of each appliance to a switch output
terminal. Connect the negative side to DC negative.
c. For label backlighting, connect your boat’s +12V or
+24V DC to the appropriate quick connect terminal.
Cover the unused terminal with the supplied protective boot.
d. For label backlighting, connect the quick connect terminal
marked –NEG to your boat’s DC negative.
COVER
PANEL
VOLTAGE LABEL
CIRCUIT LABELS GASKET
4. To remove cover, apply heal of hand to label area and pull back on the cover edge.
Application Example
12V DC
24V DC
WIRE HARNESS (BUS)
Connect adequate gauge supply wire
and circuit protection for safe operation
up to Panel Cumulative Rating.
PN 4316 shown
for illustration
purposes
VHF
BILGE PUMP
FISH FINDER
STEREO
HORN
GPS
EXAMPLE DEVICES
COMMON BUSBAR
To Battery Positive
To Battery Positive
Legend
DC Positive
DC Negative
FUSE
OR
COVER PANEL WALL CUT-OUT GASKET
SWITCH
BOOTS
CIRCUIT
BREAKER
BOOTS
5. Securely tighten switch and circuit breaker boots.
Mount panel in cutout with provided gaskets and screws.
Reattach the cover