Carlin 702G/O Inst Manual - Manual (Page 2)

Model 702G/O Advanced gas/oil burners — Instruction manual
Carlin part number MN702GO Rev. 06/23/14
– 2 –
Where appliance instructions differ from this manual, follow the appliance instructions.
Contents
PLEASE read this first .................................................................2
General information .....................................................................3
1. The Carlin Model 702G/O combination gas/oil burner ...........4
2. Prepare site • assemble burner • mount burner .............6
3. Install gas piping ...................................................................12
4. Install oil piping .....................................................................14
5. Wire the burner .....................................................................16
6. Checkout procedure — before starting the burner ...............18
7. Set burner initial head and damper positions .......................19
8. Adjust the burner using test instruments ..............................20
9. Maintenance and service procedures ..................................24
10. Repair parts ........................................................................26
11. Dimensions .........................................................................30
User care and maintenance ........................................Rear cover
PLEASE read this first . . .
Special attention flags . . .
Please pay particular attention to the following when you see them
throughout this manual.
Notifies you of hazards that WILL cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that CAN cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor
personal injury or property damage.
Notifies you of special instructions on installation, operation
or maintenance that are important, but are not normally
related to injury or property damage hazards.
Before installing or
servicing:
Should overheating occur:
(1) Shut off the oil and gas supplies to the burner.
(2) DO NOT shut off the control switch to the boiler
circulator or the burner.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property dam-
age.
Installer/service technician . . .
•
Read all instructions before proceeding. Perform all procedures,
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
•
Before leaving the site after startup or service, review the User
care and maintenance page with the user. Make the user aware
of all potential hazards and perform the training outlined below.
Installer/service technician —
Train the user . . .
•
To properly operate the burner/appliance per this manual and
the appliance instructions. See User care and maintenance.
•
To keep this manual at or near the burner/appliance for ready
access by the user and service technician.
•
To contact the service technician or oil dealer if he encounters
problems with the burner/appliance.
•
To keep the appliance space free of flammable liquids or vapors
and other combustible materials.
•
To never use laundry products, paints, varnishes or other chemi-
cals in the room occupied by the burner/appliance.
•
To contact the service technician at least annually for startup and
burner/appliance service.
When servicing the burner . . .
•
DISCONNECT ELECTRICAL SUPPLY and all other electrical
connections to burner before attempting to service to avoid
electrical shock or possible injury from moving parts.
•
CLOSE all manual gas and oil valves before disconnecting any
portion of fuel lines and before cleaning or removing any parts
from the burner or related equipment.
•
Burner and appliance components can be extremely hot. Allow
all parts to cool before attempting to handle or service to avoid
potential of severe burns.