Carlin 702G/O Inst Manual - Manual (Page 32)

Model 702G/O Advanced gas/oil burners — Instruction manual
Carlin part number MN702GO Rev. 06/23/14
– 32 –
Where appliance instructions differ from this manual, follow the appliance instructions.
User care and maintenance
Refer only to the information on
this page, intended for your use.
The remainder of this manual is
intended only for your service
technician. Failure to comply could
result in severe personal injury,
death or substantial property dam-
age.
For other than routine maintenance, contact
a qualified service company. Perform the
following as needed.
• Keep the area around the burner clear
and free from combustible vapors and
liquids.
• Do not obstruct the flow of combustion
and ventilating air.
• Most motors currently used on residential
type burners use permanently-lubricated
bearings, and do not require field lubri-
cation. Read the label on the motor to
determine oiling needs, if any. Do not
over-lubricate. This can cause as much
trouble as not lubricating at all.
Never attempt to use gasoline as
a fuel for this burner, as it is more
combustible and could result in a
serious explosion. Never attempt
to burn refuse or use any fuel other
than # 1 or # 2 heating oil (ASTM
D396).
702G/O burner
Should overheating occur:
(1) Shut off both fuel supplies to the burner.
(2) DO NOT shut off the control switch to
the circulator or blower.
(3) Contact your oil dealer or service
technician and the fire department (if
needed).
The burner must be cleaned, tested and
adjusted annually by a qualified burner
service technician.