CiDRA SONARtrac PW VF-100 - Manual (Page 44)

20831-01 Rev 05 Page 5-26
Cover lower
support strap
assembly
c. Thread the strap loose end through the take-up spindle and
pull slack strap through the spindle before tightening using the
ratchet.
Figure 22 Sensor Cover Support Installation Kit on Pipe
8. Lift the upper sensor cover into place on the cover lower support
strap assembly.
9. Install a cover support strap between the cover upper handle and
the cover upper support strap.
a. Cover sizes 2 thru 4-inch (50 – 100 mm) do not have lifting
handles. Wrap a length of the hook and loop strap around the
cover to hold the halves in place.
10. Repeat above steps with lower cover assembly.
11. Open the access panel to ensure the sensor band cable is
accessible.
Cover upper
support strap
Lower cover boot seal
sitting on cover lower
support strap assembly