Dascom 2600 User Guide - Manual (Page 37)

Tally Dascom 2610
24
4.2.2 Online mode
After switching on, the printer is automatically set to online mode.
Only in this mode can it receive data from the computer.
■ Online key: Toggle between Online and Offline mode.
■
Tear key (4): Activates the tear function when fanfold paper
is loaded.
If Load is displayed above this key, no paper is loaded
in the printer or the paper is in park position. In this case the
display switches between Online and Park Position. Press
the key to feed paper to the printing position.
■ Setup key: Sets the printer to setup mode.
4.2.3 Offline mode
Only in this mode is it possible to perform step, line, or form feeds from the control panel,
however, data cannot be received.
■ Park key (1)
If fanfold paper is loaded in the printer, it is fed to the
park position or the tear position. If a single sheet is
loaded, it is ejected.
■  key (2)
Each press: Paper is transported upwards step by step.
Holding: Continuous transport upwards.
■  key (3)
Each press: Paper is transported downwards step by step.
Holding: Continuous transport downwards.
■  LF/FF (4)
Paper in the printer:
Each press: performs a line feed (LF).
Holding: performs a form feed (FF).
■ Load key (4)
No paper in the printer: The press on this key loads the
paper to the first print position.
■ Setup key: Sets the printer to setup mode.
■ Online key: Sets the printer to online mode.