Dascom 2600 User Guide - Manual (Page 55)

Tally Dascom 2610
42
5.4.2 Advanced Menu
Advanced
Menu
Valid Settings Function
ASCII80 8 inch wide print of test pattern To check operational readiness, your
printer contains a self-test routine which
allows testing of the printer
configuration, the print quality and
correct operation of your printer.
ASCII136 13.6 inch wide print of test pattern
(only 2610)
H-Dump With the interface test
(Hex-Dump/H-Dump) you can test data
transmission from the computer to the
printer. During this test, the data from the
computer is printed out in two columns.
The text in the left column is printed in
hexadecimal format and in the right
column in ASCII format.
Hvy Form HvyForm=ON
HvyForm=OFF
If you set HvyForm=ON, the printer
prints the same line twice at double
strike. This setting ensures that copy
paper produces optimum results.
Formlen 12” 11” The Formlen function allows you to set
the basic (default) form length to meet
your requirements. 11 inches are usual
in the USA, as opposed to 12 inches in
Europe.
Paphand
PLM On Off
This item’s full name is Paper Load
Mode. It is located beneath the already
existing menu item “Paphand”(Paper
Handling).
This setting enables(on)/disables(off) a
horizontal carriage movement in order to
flatten the paper so it finds its way into
the upper friction.
However the movement is determined
by the menu items Pagewid & Widthcon.
If Widthcon=Off
2600: The movement of carriage goes
all the way = 8”
2610: The movement of carriage goes
all the way = 13.6”
If Widthcon=On
2600/2610: The movement of carriage
goes rightmost to Pagewid Position.
This function is ON by default and is
valid for Rear Tractor only.
Pagewid 2610: 20
— 136 /10”
2600: 20—80 /10”
Parameter “Pagewid”. This item’s full
name is Pagewidth.
It is located beneath the already existing