Dascom 2600 User Guide - Manual (Page 59)

Tally Dascom 2610
46
5.5 Display messages
If the printer detects an internal fault or user error or if it expects you to do something, a
message will appear in the LC display (LED’s display message reference below table 5.6.1).
It also displays the status during an operation (e.g.
Initializing). Below you will find a list of
messages with brief descriptions of each message.
5.5.1 Messages LED Panel
LED Messages Error/Power ON Online Tractor Speed Pap.Out Power/Err.
Hardware Alarm blink blink blink blink blink
Switch Paper lever
(intermediate beep)
Off normal normal blink blink
Paper Width Error blink off blink blink blink
EEPROM Error blink blink off blink blink
Serial Interface Error blink blink blink off blink
“Printhead Hot” Message blink off off blink blink
“Check Ribbon” Message blink off off off blink
Serial Boot Mode on on off on Off
Parallel Boot Mode on off off on off
RAM Error off on on on off
Missing FPGA off on on on on
Monitor Mode for ROM
Debugger
on on on off off
Wrong Header (temporary) on off off off off
Sensor Controller (ST8) Error off off on on off
Firmware Download Is
Running
One lit LED is moving around in a circle, the others
are off
If one of the messages cannot be removed by power cycling the printer call your
service.