Bowflex TreadClimber TC5000 - Manual (Page 20)

17 Bowflex ® TreadClimber ® Owner’s Manual
Assembly Guide
Step 6: INSTALLING THE UPRIGHTS
Locate the following for this step:
PARTS:
• TreadClimber ® Base & Treadle Assembly from
Step 5.
• One (1) Left Upright Support & Hydraulic
Cylinder
• One (1) Right Upright Support & Hydraulic
Cylinder
HARDWARE:
• Two (2) 5/16” x 1” Button Head Screws
6-1 On the base assembly screw a 5/16" x 1" button
head screw half way in on the outside of both
the right and left lower upright bracket (see
Figure 6-1).
6-2 Place the left upright onto the left upright bracket
(see Figure 6-2), so it rests on the button head
screw (see Figure 6-3). Make sure the cylinder
bracket is at the top and pointing to rear.
6-3 Repeat this process on the right side.
Step 7: INSTALLING THE UPRIGHT
JUNCTION COVERS AND
COSMETIC PLUGS
Locate the following for this step:
PARTS:
• TreadClimber ® Base & Treadle Assembly from
Step 6.
• Two (2) Plastic Upright Junction Covers
HARDWARE:
• Four (4) Cosmetic Plugs
7-1 Place the plastic upright junction covers onto
the top of left upright support (see Figure 7-1).
7-2 Insert the cosmetic plugs (2 per side) into the
holes on the top, inside and outside of the left
upright support (see Figure 7-2).
7-3 Repeat this process on the right side.
Figure 6-3
Figure 6-2
Figure 6-1
Figure 7-2
Figure 7-1