Bowflex TreadClimber TC5000 - Manual (Page 28)

25 Bowflex ® TreadClimber ® Owner’s Manual
Assembly Guide
Explanation of Calibration Display Messages (for information only):
During calibration, the TIME display will show you text messages updating you as to the status of
calibration. When there is no text message in the TIME display window, the other displays will show the
following:
HEART RATE (TC5000 Only) – will show the status of the motor control relay.
• “ON” signifies the power relay is on and energizing the motor.
• “OFF” signifies the motor control relay is off and not energizing the motor.
CALORIES/CAL PER MIN – will show the version number of the software.
TIME – will show either a text message regarding auto-calibration (“d0nE”, “Strt”, etc.) or the actual
Pulse Width Modulation (PWM) number (a number that provides digital information about
base unit functions to the console) if START/STOP, FASTER or SLOWER is pressed during
calibration.
MILES/TOTAL STEPS (DISTANCE/MILES for TC3000) – will show the calibration of the total
step count.
SPEED – will display the actual belt speed during the calibration function.
19-7 Release the POWER and SLOWER buttons.
The TIME display will read “CAL”, “PrSS”,
“Strt”.
19-8 Press the START/STOP button. This will start
the calibration procedure.
19-9 During the calibration procedure, the belts
will start and stop and the displays will show
various numbers that relate to calibration—DO
NOT INTERRUPT CALIBRATION.
19-10 When calibration has completed “CAL”
“PASS” will show in the TIME display.
19-11 Remove and re-insert the Safety Key to clear
the displays.
When the Bowflex ® TreadClimber ® exercise
machine has completed calibration, you may begin
your workout.
NOTE: During calibration 100
ft
LED on
TC5000 signifies belt speed sensor,
1000
ft
LED is step sensor. During
calibration, some models of the
TC3000 will show the step sensor in
the DISTANCE window as a heart
and the speed sensor in the SPEED
window as a heart.