Eschenbach Optik Andromeda - Manual (Page 8)

Page 8
Rev E EN
Symbol Name Basic function
Function button 1 The user can decide the function of these
buttons by using the Configuration Menu
described later.
Although not on the front panel, the
footswitch acts as an additional function
button and is programmed in the same
way as the other function buttons.
Function button 2
Function button 3
Footswitch
Brightness
Pressing this button on the right or left
increases and decreases the brightness
or contrast of the image.
Mode
The mode button switches between
picture mode (for viewing pictures and
images) and reading modes (high
contrast mode). A single press will switch
from picture mode to the last used
reading mode (positive or reversed) or
vice versa. A subsequent press within 2
seconds will switch to the other reading
mode.
Pressing and holding this button for 2
seconds will bring up the Configuration
Menu, described in Section 5 below.
4. Basic Functions
This section will describe how to use the basic features of the
Andromeda to magnify text and images. Follow the instructions in
section 1 – Setting Up before you begin using the unit.
4A. Reading Table
Unlock the table and place the material you want to read on it. The
table should slide easily in all directions. After transport, the bearing
carriers in the table slides may have moved, tending to restrict the
extent of the movement – this is normal. To correct this, extend the
table in all directions to its full extent, applying sufficient force to re-align
the bearing carriers.