ETC LED Configuration Software Programming Guide - Manual (Page 18)

15 LED Configuration Software 1.0 Programming Guide
Status
The Status tab displays LED temperatures and fixture messages and errors of the selected
fixtures in the Discovered Devices pane. Use this property tab for diagnosis. You cannot
change anything on this tab.
Send DMX
Use the Send DMX tab to control the fixtures using DMX and fine tune the selected Quick
Setup. The properties of this tab change to match the selected Quick Setup.
This tab is not available with gateways.
Figure-1.9 Send DMX tab for the XT Arch Setup.
N o t e :
Not all functionality of LED Config Tool may be available for the fixture you are
configuring. Refer to the fixture’s user manual for information about its functionality.
Step 1: In the Discovered Devices pane, select the fixture to be controlled.
Step 2: On the Send DMX tab, using the cursor, drag the slider of each property to
achieve the desired result.
Step 3: Click Zero All to return all sliders to zero.