ETC LED Configuration Software Programming Guide - Manual (Page 7)

1
Operation 4
Overview
LED Config runs on a computer that can be connected to the DMX/RDM network via
Gadget or a DMX/RDM gateway. After the fixtures are configured, Gadget or the gateway
can be disconnected and a DMX/RDM lighting control device can be connected to the
network for continued operation.
Figure-1.1 Architecture of using LED Config Tool to configure fixtures on a network.
N O T E :
LED Configuration software should be installed prior to attaching Gadget or a gateway to
the computer to ensure that the Windows driver is installed.
Gadget or a gateway should be connected to the PC before running Configuration
software.
Up to 32 fixtures
Gadget
Console
DMX/RMD network
PC with LED Configuration software
Or
DMX/RDM
gateway