ETC LED Configuration Software Programming Guide - Manual (Page 8)

5 LED Configuration Software 1.0 Programming Guide
LED Config Tool Interface
The LED Config Tool interface window consists of panes and tabs. Each displays
information or allows you to configure the connected fixtures.
Figure-1.2 LED Config interface Quick Setups tab window.
N o t e : Not all functionality of LED Config Tool may be available for the fixture you are
configuring. Refer to the fixture’s user manual for information about its functionality.
Before you launch the LED Config Tool software, connect Gadget or a gateway to the
computer. LED Config will then recognize the connected devices.
Refer to Gadget USB to DMX/RDM Interface Setup Guide or the gateway’s user manual
for using these devices.
Discovered Devices pane
Status bar
Properties tabs