ETC LED Configuration Software Programming Guide - Manual (Page 9)

1
Operation 6
Discovered Devices
When the computer is connected to the network or via USB and the connected fixtures are
turned on, LED Config Tool discovers the fixtures on the network and displays them in the
Discovered Devices pane. To view details about the selected fixture, click the arrow next to
the fixture name.
You select a fixture in the Discovered Devices pane to configure it.
Properties Tabs
The properties of each tab are determined by the Quick Setup that is selected on the Quick
Setup tab.
Identify
Click Identify Fixture to identify the fixture that is selected in the Discovered Devices
pane. The fixture flashes on and off. Click Stop Identify Fixture to stop the identification.
Figure-1.3 Identify and DMX Address panes.
DMX Address
Use DMX Address to assign a DMX address to fixtures. Select a fixture in the Discovered
Devices pane and then enter the DMX address for the fixture. The DMX address is
selectable from 1 to 510.