EUCHNER MGB-L2-xxxAPx-xxx - Manual (Page 2)

2
Operating Instructions MGB-L1...AR.-... / MGB-L2...AR.-... and MGB-L1...AP.-... / MGB-L2...AP.-...
Contents
1 About these operating instructions 3
1.1 Scope 3
1.2 Symbols used 3
2 Correct use 4
3 Exclusion of liability and warranty 5
4 General safety instructions 6
5 Function 7
6 System Overview 8
6.1 Locking module MGB-L.-... 8
6.2 Handle module MGB-H-... 8
6.3 Escape release MGB-E-... (optional) 8
6.4 Dimension drawing 9
6.5 Mechanical release 10
6.6 Lockout bar 11
6.7 Escape release (optional) 12
7 Mounting 14
7.1 Mounting color cover 14
8 Changing actuating direction (here: from right to left) 16
9 Protection against environmental effects 17
10 Electrical connection 18
10.1 Safety in case of faults 19
10.2 Fuse protection for power supply 19
10.3 Requirements for connection cables 20
10.4 Notes on cable laying 20
10.5 Changing device configuration (using DIPswitches) 21
10.6 Notes on operation with control systems 24
10.7 Terminal assignment and contact description 25
10.8 Operation as separate device 26
10.9 Operation in an AR switch chain 27
10.10 Information on operation in an AR switch chain 28
11 Setup 29
11.1 Teach-in operation (only for MGB unicode) 29
11.2 Mechanical function test 29
11.3 Electrical function test 30
12 Technical data 31
12.1 Typical system times 32
13 System states 32
13.1 Key to symbols 32
13.2 System status table MGB-AR 33
13.3 System status table MGB-AP 34
14 Troubleshooting and assistance 35
14.1 Fault reset 35
14.2 Help on troubleshooting in the Internet 35
14.3 Help on mounting in the Internet 35
15 Service 35
16 Inspection and service 36
17 Declaration of conformity 37