EUCHNER MGB-L2-xxxAPx-xxx - Manual (Page 21)

21
Operating Instructions MGB-L1...AR.-... / MGB-L2...AR.-... and MGB-L1...AP.-... / MGB-L2...AP.-...
10.5 Changing device configuration (using DIPswitches)
Tip!
You will find an animation on device configuration at www.mgb.EUCHNER.de.
DIPswitch
The devices can be configured using the DIPswitches. The following settings are
possible:
Ì Changing system family (AR/AP switching)
Ì Deactivating guard lock monitoring
Ì Activate release monitoring (possible only with active guard lock monitoring)
Position of the switches
Item Description
1 DIPswitch
2 Sticker with factory setting
Function of the switches
Detail Switch Function
A 1+2 on: Device is operated as AP system
off: Device is operated as AR system
B 3+4 on: Guard lock monitoring is deactivated
off: Guard lock monitoring is active (usually factory setting)
C 5 on: Configuration possible
off: Configuration inhibited (factory setting)
D 6 on: release monitoring is activated
off: release monitoring is deactivated (factory setting)
Changing system family (AR/AP switching)
Caution!
Malfunction due to incorrect configuration or incorrect connection.
Ì Note that the terminal assignment assignment also changes on changing the
configuration (see section 10.7 Terminal assignment and contact descrip-
tion, page 25).
1. Switch off power supply.
2. Set DIPswitches 1,2 and 5 as shown.
For changing from AR => AP For changing from AP => AR
1
ON
2 3 4 5 6 1
ON
2 3 4 5 6
3. Switch the power supply on for at least 5 seconds.
¨ The change is confirmed by the illumination of the Power LED. All other LEDs
are off.
4. Switch off power supply and set DIPswitch 5 to OFF.
¨ The next time the device is started, it operates in the operating mode set.
1
2
1
ON
2 3 4 5 6
A B C D