FasTest TwistMate Serie Seal Replacement - Manual

REPLACMENT INSTRUCTIONS
Roseville, MN
Ph: 1-800-444-2373
Fax: 651-645-7390
www.fastestinc.com
WP015 10/6/2010
BODY (E)
SLEEVE (D)
FACE SEAL (A)
O-RING (B)
REMOVE
SLEEVE INSTALL
WITH SLIGHT TWIST
FACE SEAL (A)
SLEEVE (D)
SLEEVE
FITTING (E)
RET. RING (F)
BODY (G)
BACK-UP RING (C) O-RING (B)
SLEEVE
O-RING (H) BACK-UP RING (I)
RET. RING (F)
SLEEVE INSTALL
WITH SLIGHT TWIST
FINISHED
ASSEMBLY FINISHED
ASSEMBLY
BACK-UP RING (C)
FACE SEAL
Male Plug and Male Extended Connector Seal Replacement:
1. Remove face seal (A) from connector using a sharp tool and save. Face seals sold separately.
2. Remove sleeve (D) to expose o-ring (B) and back-up ring (C). Remove and discard old
o-ring and back-up ring.
3. Make sure body (E) and sleeve (D) are clean and free of dust and dirt before reassembling new
components to the connector.
4. Install new back-up ring (C) as shown.
5. Lubricate new o-ring (B) with petroleum jelly and install as shown.
6. Replace sleeve (D) and use a slight twisting motion to ensure that the seals remain in the ring groove.
7. Install face seal (A).
Male Swivel Connector Seal Replacement:
1. Remove face seal (A) from connector using a sharp tool and save. Face seals sold separately.
2. Remove sleeve (D) to expose o-ring (B) and back-up ring (C). Remove and discard old
o-ring and back-up ring.
3. Make sure body and sleeve are clean and free of dust and dirt before reassembling new components to
the connector.
4. Install new back-up ring (C) as shown.
5. Lubricate new o-ring (B) with petroleum jelly
and install as shown.
6. Replace sleeve (D) and use a slight twisting motion to ensure that the seals remain in the ring groove.
7. Install face seal (A).
8. Remove ret. ring (F) and discard. (This can be difficult; a sharp, stiff, bent tip pick is required).
9. Remove fitting (E).
10. Remove and replace back-up ring (I).
11. Remove and replace o-ring (H), lube new o-ring.
12. Install fitting (E). Use a slight twisting motion to ensure that the seals remain in the ring groove.
13. Install the retaining ring, making sure it is
completely seated in its groove.