Garland SHDUBA10000 INDUCTION DUAL-ZONE BASE-LINE COOKERS - Manual (Page 15)

Operating Instructions RTCSmp Induction Dual Base-Line Cookers
Part # 4532290 Rev 2 (1/15/14) 15
• Material
Use cookware made of conductive and magnetic materials. If the pan bottom attracts a magnet,
the pan is suitable for induction cooking. Look for cookware that is labeled “suitable for induction”
or has an induction compatible symbol on the pan bottom.
Boil Test
To verify the performance of a pan for induction cooking: Add one liter of cold water into the pan
and bring it to boil. The time needed to boil one liter of water should be:
• SH/DU/BA 7000 (2x3500W), approximately 140 seconds
• SH/DU/BA 10000 (2x5000W), approximately 85 seconds
If the time to boil exceeds the above guideline, then the pan material is not suitable for achieving
optimal efficiency. Please contact your supplier to purchase suitable induction pans.
6.2 Proper Placement of Cookware on Dual Hobs
The RTCSmp Dual Countertop model has two cook zones (dual hobs). Each cook-zone is equipped with the latest
RTCSmp sensor technology which enables temperature controls in realtime. To obtain the optimal results from
the sensors, you must always place the pan in the center of the hob, which is indicated by the markings on the
glass.
CAUTION
Pans and pots must not cover more than one cook
zone. Otherwise, electronic components of the
induction unit can be damaged.
DO NOT
(A): Place one pan over two cook-zones.
(B): Place multiple pans on a single cook-zone.
DO
(C) and (D): Place one pan on each hob, and each
pan is placed in the center of the hob.
6.3 Power Control
Set the desired power level by turning the control knob and the unit is immediately ready for operation. When
the green indicator lamp lights up, energy is being transferred to the cookware.
ON-Position
Any position where
“0” is not pointing to
the LED indicator
light. The LED is on. OFF-Position
“0” is pointing to the
LED indicator light. The
LED is off.
Set and adjust the power level by turning the control knob:
• Position (1) indicates minimum power.
• Position (12) indicates maximum power.