INFICON Q-pod Thin Film Deposition Monitor - Manual (Page 19)

2 - 1
IP
N 07
4-
54
7-
P1
B
Q-pod Operating Manual
Chapter 2
Quick Start
2.1 Install Software
NOTE: If this is the initial Q-pod installation on this computer, you should install the
Q-pod Software before connecting a Q-pod to the USB port.
1 Place the INFICON Program Disk in the computer’s CD-ROM.
2 Ignore the prompt and double-click the My Computer icon.
3 Right-click the CD-ROM icon, then click Open.
4 Double-click the Q-pod Transducer file.
5 Double click QPOD_V#_SETUP.EXE.
6 Follow the on screen directions and select the default installation options.
7 When software installation is complete, exit the installation program.
2.2 Connect the Q-pod
1 Connect the USB cable to a computer USB port, then to the Q-pod. See Figure
2-1 .
1a If you are prompted to install the Q-pod drivers, select Install the Software
Automatically.
1b If you are prompted concerning Windows Logo Testing, select Continue
Anyway.
Figure 2-1 Q-pod Connections