5 crystal snatcher – INFICON Q-pod Thin Film Deposition Monitor User Manual
Page 42
Advertising
4 - 14
IP
N 07
4-
54
7-
P1
B
Q-pod Operating Manual
4.2.5 Crystal Snatcher
Use the crystal snatcher, supplied with the sensor, as follows:
1
Insert crystal snatcher into ceramic retainer (1) and apply a small amount of
pressure. This locks the retainer to the snatcher and allows the retainer to be
pulled straight out (2). See
.
2
Reinsert the retainer into the holder after the crystal has been replaced.
3
Release the crystal snatcher with a slight side-to-side motion.
Figure 4-6 Use of the Crystal Snatcher
Advertising