INFICON SKY CDGxxxD (EtherCAT) - Manual (Page 28)

28
tira68e1 (2013-05) CDGxxxD.cp
If the device consists out of several software portions this parameter should be
used.
Using standard a.b.c.d format to describe a version:
SW Version VPG PCB (Index F940)
a
b
c
d Mayor revision
Minor revision
Development revision
Vendor specific
i.e. 1.0.1.2
Execution of this command will start a Zero Adjust operation.
Index SI DataType NV Access PM Name
FB40 0x01 V_STRING RW Command
0x02 BYTE RO Status
0x03 V_STRING RO Response
If the device consists out of several software portions this parameter should be
used.
Using standard a.b.c.d format to describe a version:
Command
Byte 0
0: Zero adjust with no offset
1: Zero adjust with zero offset
2: Zero adjust with target offset
Byte 1 Index of the Sub Sensor Instance (1)
Byte 2…5 Offset value (Data format: REAL, always 0)
Status (supported values)
0
1
2
3
255
Last command completed, no errors, no reply available
Last command completed, no errors, reply available
Last command completed, errors present, no reply
available
Last command completed, errors present, reply available
Command is executing
Response
Byte 0
See Subindex 0x02
Byte 1 Unused
Byte 2 0: Zeroing successful
1: Zeroing failed; out-of-range
2: Zeroing failed; cumulative out-of-range
3: Zeroing failed: measurement invalid
255: No previous Zero Adjust command issued
Execution of this command will start a Full Scale Adjust operation.
Index SI DataType NV Access PM Name
FB41 0x01 V_STRING RW Command
0x02 BYTE RO Status
0x03 V_STRING RO Response
Subindex 0x04 (F940)
4.7.15 Command Zero Adjust
Subindex 0x01
Subindex 0x02
Subindex 0x03
4.7.16 Full Scale Adjust