Intelix DIGI-HD-XR - Manual (Page 2)

8001 Terrace Ave
Suite #201
Middleton, WI 53562 Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
DIP Switch Settings
1. Dual/Single UTP mode – Use this DIP switch to select the mode
compatible with the other extender products you are using.
a. Dual mode will allow you to utilize the included IR pickup
to transfer IR remote codes back to the source. Dual mode
will also allow you to dynamically utilize the EDID from
connected displays. You will need to attach [2] twisted pair
cables between the “A/B” Twisted Pair Input and a
compatible transmitter (Intelix HDMI twisted pair matrix
or an IR2/3 transmitter)
b. Single mode will eliminate the ability to use the IR pickup,
and will also eliminate dynamic EDID management. You
will need to attach [1] twisted pair cable between the “A”
Twisted Pair Input and a compatible transmitter (HD
Matrix or a UHR2 transmitter)
2. Normal/Compatibility Mode – Certain sources may create an
unstable video image. This may include some cable/satellite
receivers. Try this setting if you witness an image that flashes
on/off approximately every 2 seconds.
3. FILO/AutoMix Mode – Use this DIP switch to control what set of
EDID is presented to the source. This will determine what video
resolution and audio format the source will send. Either mode
are only applicable when using Single UTP mode, EDID must be
emulated by the Send Extender (or Intelix HDMI twisted pair
matrix) when using Single UTP mode.
a. FILO mode transfers all EDID from one display to the
source. This works in a First-In, Last-Out format. EDID
from the attached display of the extender that is powered
on first will be presented to the source. All other displays
in extender chain must be compatible. Removing power
from transmitter or all receivers will reset the memory.
b. AutoMix mode will examine EDID information of ALL
attached displays in the extender chain. The source will
then be presented with an EDID table that includes the
highest compatible resolution/audio. For instance, if you
have a [3] 1080p TVs, and [1] TV that accepts 720p as the
highest resolution, the source will transmit 720p.
*The DIGI-HD-XR system must be power cycled for the changes to
take effect. Please remove ALL cables from extender, change DIP
switches then reconnect.
DIGI-HD-XR Dip Switch Settings
DIP Switch Position Function
1 Off Dual UTP Mode
On Single UTP Mode
2 Off Normal Mode
On Compatibility Mode
3 Off EDID FILO Mode (First In, Last Out)
On EDID AutoMix Mode
Instructions
1. Turn off power and disconnect the audio/video
equipment by following the manufacturer’s
instructions.
2. Adjust DIP Switches for desired mode.
3. Connect IR Eyes to DIGI-HD-XR and compatible IR
extenders. (if desired)
4. Connect IR emitters to transmitter, and apply to
source.
5. Connect all twisted pair cables.
6. Connect all HDMI cables.
7. Connect power supplies, starting with the display
with the desired EDID (FILO mode).
8. Turn attached A/V equipment power on.
9. Verify
Note: DIP switches are located under the cap on the
side of the unit.