Intelix DL-HDM44 - Manual (Page 12)

DL-HDM44 Installation Guide
12
Connect RS232 Control
The RS232 control port requires a standard straight-through serial cable for operation. The default settings for
the RS232 port are:
• 19200 baud
• 8 Data Bits
• 1 Stop Bit
• Parity = none
See page 19 for all available control commands for the DL-HDM44.
Connect a standard straight-through serial cable with DE9
connector between the RS232 port on the DL-HDM44 and
the controller.
Connect Ethernet (Web Browser) Control
The DL-HDM44 may be controlled via Ethernet through a web browser interface.
The TCP/IP port requires a standard straight-through Category
5 or greater cable with the TIA/EIA-568B crimp pattern for
optimal operation.
The default settings for the TCP/IP port are:
IP address: 192.168.0.178
TIA/EIA-568B
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
1 8
Connect the Ethernet cable between to the matrix and a router
with a straight-through cable or between the matrix and a
computer with a crossover cable.