Intelix DL-HDM44 - Manual (Page 20)

DL-HDM44 Installation Guide
20
TCP/IP Setup Commands
Description Command Response
Set static IP address SETIP<SP><IP ADDRESS><CR> SETIP<SP><IP ADDRESS><CR>
IP Address <IP ADDRESS> is
set.<CR>
Set subnet mask SETNETMASK<SP><SUBNET><CR> SETNETMASK<SP><SUBNET><CR>
NetMask Address <SUBNET> is
set.<CR>
Set gateway SETGATEWAY<SP><GATEWAY><CR> SETGATEWAY<SP><GATEWAY><CR>
GateWay Address <GATEWAY> is
set.<CR>
Set matrix to DHCP RSTIP<CR> RSTIP<CR>
<CR>
<CR><LF>
IP configuration is set to DHCP
Mode.<CR>
<CR><LF>
The new IP Address is usable
10 seconds later<CR>
Get current IP setup IPCONFIG<CR> IPCONFIG<CR>
<CR>
<CR><LF>
IP Configuration is :<CR>
<CR><LF>
[Static IP/DHCP Mode]<CR>
<CR><LF>
IP: <IP ADDRESS><CR>
<CR><LF>
NETMASK: <NETMASK><CR>
<CR><LF>
GATEWAY: <GATEWAY><CR>
<CR><LF>
HTTP PORT: 80<CR>
SETIP<SP>192.168.0.178<CR> Set static IP Address to 192.168.0.178.
Example:
EDID Commands
Description Command Response
Use built-in EDID EM1<CR> EM1<CR>
Use EDID from Output A EM2<CR> EM2<CR>