Intelix VGA-HD User Manual

Dip switch settings, Instructions

Advertising
background image


8001 Terrace Ave.
Suite #201
Middleton, WI 53562

Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833

VGA-HD Installation Guide and Technical Specifications










The Intelix VGA-HD converts computer video and stereo audio to HDMI. The unit passes through native resolutions without
scaling
to ensure picture quality.

The VGA-HD features built-in EDID tables that pass common resolutions (1920 X 1080 with stereo audio and 1280 X 720 with
stereo audio) back to the source device.

The VGA-HD also has a dynamic EDID compatibility function. The unit reads the EDID information from a destination device,
compares the accepted resolutions of the destination device to a compatibility table stored on the VGA-HD, and passes
modified EDID information back to the source device. The modified EDID information will only contain video resolutions that
are contained in both the compatibility table (on the VGA-HD) and the destination device EDID.

DIP Switch Settings

SW 1

SW 2

Mode

Down Down Read EDID data from display
Down Up

Read EDID data from display

Up

Down 720p with stereo audio

Up

Up

1080p with stereo audio

Instructions

1.

Adjust DIP switches for desired mode.

2.

Connect the HDMI cable from the converter
to the display.

3.

Apply power to the display.

4.

Connect the stereo audio cable from the
converter to the source.

5.

Apply power to the converter.

6.

Connect the VGA cable from the source to
the converter.

Important notice:

Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside
the unit. Doing so will void your warranty.

To minimize the possibility of equipment damage
from electrostatic discharge (ESD), all source and
destination equipment must be powered off during
installation.

Allow proper ventilation to reduce the risk of thermal
failure.

Advertising