I.R.I.S. 402 User Manual
Page 28
Media Type (Continued):
Motion Configuration:
Up to 3 MD (Motion Detection) areas can be enabled. Each MD can be individually enabled/disabled,
covering range defined and trigger sensitivity set.
To enable and verify MD areas, follow the steps provided below:
1.
Check the box to enable the motion area
2.
Drag and drop to position the motion window
3.
Hold and drag any corner of the rectangle to resize the window.
4.
Adjust the detection “Sensitivity” and “Object Size” of the MD area by dragging the pin of the slider
bars.
NOTE:
The “Sensitivity” setting applies to the sensitivity level of the motion detection feature; the higher the value,
the more sensitive the activation trigger. “Object Size” indicates the trigger threshold. A lower “Object Size”
value means it is easier to exceed the value, and thus trigger the motion event.
5.
The status chart shows motion activities. When the motion vector exceeds a threshold (the Object
Size), the motion trigger is activated.
6.
To enable other motion areas, repeat the steps above.
7.
Click on the “Apply” button to save the settings.