I.R.I.S. 402 - Manual (Page 38)

Restore to Default Settings :
In certain situations whereby the camera ‘locks up’ or fails to respond to communications / commands etc it
may be necessary to carry out a system reset, restoring the cameras configuration to it’s factory settings.
This is achieved by using the Reset button.
Due to the water-resistance design, the Reset button is located inside the housing. To press the Reset
button, it is necessary to open the rear cover. To learn the procedures, please refer to the previous “Install a
Micro- SD card” section.
1. Restart / Reboot the device
Press and release the Reset Button. Within 1 second, the system will be restarted (the LED Indicator will
be steady amber). Upon successful reboot, the LED will be steady green during normal operation.
2. Reset User Management
Press and hold the Reset Button until (around 5 seconds) the LED Indicator flashes green. User
management settings will be reset to default (the LED keeps amber during the process). Upon successful
restore, the LED will be steady green during normal operation.
3. Reset to factory default settings
Press and hold the Reset Button until (over 10 seconds) the LED Indicator becomes red. The system will
start to process restoring settings (the LED keeps amber during the process). Upon successful restore, the
LED will be steady green during normal operation.
LED Indicators :
RJ45 LED’s (Standard ‘Non Waterproof‘ Models Only:
Power & System Status LED’s: