I.R.I.S. 402 - Manual (Page 7)

Setup
1. Connect the camera to a powered Ethernet source so that the unit is connected directly or indirectly to a
DHCP server.
2. The camera will adopt an I.P. address provided by the DHCP server, and will initially be displayed on the
host as a new attached device with name “-“ (Please refer to Router/DHCP server manual for relevant
instructions on performing this).
3. Once this is connected, new I.P and network details can be set via the Network setup page (page 18).
4. In the event of there being problems connecting the camera to your network, please contact your network
administrator or IP specialist quoting the cameras individual MAC address which can be found printed on
the carton label.