JUMO 706585 LOGOSCREEN fd Operating Manual - Manual (Page 107)

107
12 Configuration - Screen
12.1 Brightness … Show text image
Overview
Brightness With the aid of this function, the brightness of the screen can be altered in four
stages (1 = darker; 4 = brighter). Any alteration to this parameter will become
effective when the Instrument (device) data menu is closed.
Switch off
screen For screen saving, a screen switch-off (screen saver) can be activated here.
The switch-off can be activated by means of a waiting time or a control signal.
Time to swich off (waiting time)
If the control knob is not operated within a period from 10 to 32767 seconds,
screen saving will become active and the screen goes dark.
Binary signal (control signal)
The switch-off is initiated by one of the binary signals. A binary signal may,
forinstance, be a binary input, a relay state, or a batch activation.
Lock control
knob A binary signal can be selected with the function. It can be used to lock the
control knob as long as the signal is active.
Simulate
inputs If the parameter is activated (“Yes”), all recorder inputs and outputs will be
ignored and pseudo data will be displayed on the screen.
A
The inputs and outputs move to a non-defined state. This
parameter should only be activated for test purposes, and only if
the relays and binary outputs are not wired up.