JUMO 706585 LOGOSCREEN fd Operating Manual - Manual (Page 34)

2 Instrument Description
34
Ext. binary input Binary signals are used to indicate the switching states of the external binary
inputs. Up to 54 external binary inputs are available.
v Chapter 17 “Configuration - External Binary Inputs”
Alarms, ext.
binary input If the alarm configuration of an external binary input is active, the switching
state is indicated through the corresponding binary signal.
v Chapter 17.2 “Alarm Configuration”
Alarms, analog
inputs The alarm monitoring states of the internal analog inputs are indicated by the
binary signals. Depending on the instrument hardware level, up to 18 internal
analog inputs are available. There are two binary alarm signals for each analog
input.
v Chapter 13 “Configuration - Analog Inputs”
Math
alarms If the alarm configuration in the math module is active then the alarm is ren-
dered through the corresponding binary signal.
Alarms,
counters/integr. The alarm monitoring states of the counters/integrators are indicated by the
binary signals. 27 counters/integrators are available. There are two binary
alarm signals for each counter/integrator.
Group alarms The binary signals are used to indicate whether an infringement of the
tolerance band is present within a group, or whether there is an alarm for an
analog or binary channel. The individual channel alarms are OR-linked.
Infringement of tolerance band, group 1 — 9
There are two binary signals for each group:
• Alarm1 TL Group 1 — 9 = positive tolerance band infringement on a
channel and
• Alarm2 TL Group 1 — 9 = negative tolerance band infringement on a
channel and
v Chapter 18.2 “Analog Channels”
Alarm group 1 — 9
There is a binary signal for each group:
• Alarm Group 1 — 9 = alarm for an analog or binary channel in the
corresponding group.
v Chapter 13.4 “Alarm configuration”
Alarms, ext.
Analoginputs The alarm monitoring states of the external analog inputs are indicated by the
binary signals. 54 external analog inputs are available. There are two binary
alarm signals for each external analog input.
v Chapter 13 “Configuration - Analog Inputs”