JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual - Manual (Page 104)

12 Appendix
104
12.3 Status messages
The following status messages are indicated in the LED dot-matrix display:
Display Description
INITIALISATION - The printing recorder is being initialised.
STOP - The recorder is in the stop status, because
the
S key has been pressed.
EXTERNAL STOP - The recorder is in the stop status, because
the “external stop” has been activated by
closing the corresponding logic input.
SETUP - The setup connector has been inserted
into the recorder.
- The instrument is ready for communication
with the PC connected to it.
PLEASE WAIT! - The configuration data are being written to
the EEPROM. The recorder will not
respond to any inputs during this time.