4 configuration table – JUMO 706030 LOGOPRINT 500 Printing Recorder Operating Manual User Manual
Page 61
61
4 Configuration table
Limit comparator
Configuration level 1
➔ Limit comparator
X Limit comparator
1 — 8
Select limit comparator
Limit value:
-9999 to +9999
Enter value for limit
Lower differential:
0 — 9999
Enter the hysteresis below
the limit value
Upper differential:
0 — 9999
Enter the hysteresis above
the limit value
LK-function:
(LK=limit comparator)
lk7, lk8
Select limit comparator
function
Probe break:
OFF = 0, ON = 1,
CONST.
Determine relay state for a
probe break
(CONST. = constant: limit
state will be held)
Limit-text status:
OFF, ON
Enter status for the print-
out of out-of-limit signals
(for OFF, text entries are
not required)
TXT L:
(L = lower)
16 characters
Text for going below the
limit value
TXT H:
(H = higher)
16 characters
Text for exceeding the limit
value
Channel:
1 — 3 or 1 — 6
Select reference channel
for the limit comparator
Limit operation
(limit feed)
Configuration level 1
➔ Limit feed
X Limit feed
1 — 3 or 1 — 6
Select reference channel
Status:
ON, OFF
Select status for limits
Low:
-9999 to +9999
Enter lower limit, if status
is ON
High:
-9999 to +9999
Enter upper limit, if status
is ON
Parameter
Value/selection
Description