KD Scientific Adagio Control Software for Legato Series Manual - Manual (Page 11)

Adagio User Manual © 2010 KD Scientific
5619-001 Rev B
11
Pressing the Refresh button of the window updates the status of all the
currently defined pumps. To do that, the application establishes
communications with each of the defined pumps in order to determine
their current availability (that is, whether they are currently connected to
the computer or not) and to obtain their corresponding pump model.
When connecting a new pump model, use the Add new… function.
Do not attempt to edit an existing connection for a new pump model.
Pressing the Pump Control button launches the Manual Pump Control
tool for the selected pump. This button is only enabled when one defined
pump with “
green ” status is highlighted. Refer to section 3.3. “Manual
Pump Control” for more details.
Pressing the Accept button closes the Pump Configuration window and
stores the defined pumps list so that it is considered within the rest of the
application’s functionalities.
Pressing the Cancel button of the window asks you to confirm whether to
ignore the changes made within the list of defined pumps (so that the
application’s configuration is not altered). Only if you accept the
confirmation will the Pump Configuration window close. If no changes
were made to the list of defined pumps, the confirmation message is not
shown.
3.1. Pump Configuration Assistant
In order to facilitate the definition of new pumps and the modification of
defined pumps, Adagio provides the Pump Configuration Assistant
which arranges the process into three steps:
3.1.1. Setting pump name and connection details
To define a new pump, in the Pump Configuration screen press the Add
New button, this will launch the Pump Configuration Assistant.